3/17/2024 0 Comments Polish job kahr mk9I don’t mind too much as it does not impact performance, but I did lightly sand all of the surfaces of the Magguts that come in contact with the interior walls of the magazine. The Maggots follower scrapes against the inside of the magazine in a way the plastic OEM follower did not. I don’t care about cosmetics, but I do care about drag that might result in a failure to feed, so with some sandpaper I smoothed the sharp edge of the magazine lips, which reduced the scratching of the rounds. I love how the kit turns a 6 round magazine into a 7 round with no change in size.īecause the springs are more powerful, the top round was being pushed into the lips of the magazine so hard that each round was scratched by the lips. Magguts follower is an improvement over OEM in positioning the top round and in holding the slide stop up when the magazine in empty. There is an installation video online that is slightly outdated as the lower spring is now a different design. Installing the Magguts in my OEM Kahr CW380 magazine was straightforward. The ordering and shipping process went smoothly and met my expectations.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |